It is currently Thu Jul 24, 2014 12:07 pm

Post a new topicPost a reply Page 1 of 1   [ 1 post ]
Author Message
 Post subject: Arduino with OneWire Sensors
PostPosted: Fri Jun 07, 2013 12:35 pm 

Joined: Fri Jun 07, 2013 12:22 pm
Posts: 1
Hey there,

First time posting. Referred by a friend. My apologies if this isn't meant for troubleshooting.

Anyhow, I built an aquaponics greenhouse being run by arduino, but it's having problems.

I'm using an Arduino Due with DS18B20 Temperature Sensors ( on a OneWire Bus. The +5V and Gnd wires are connected to the arduino through a breadboard and wire nuts. The communication lines are run through the breadboard, connected to +5V through a 4.7 kOhm pullup. Wire length is about 10-15' per sensor.

My six sensors all worked, though somewhat intermittently, for 6 months. Recently they stopped. Now I can't get a sensor search to work, and can only get one sensor at a time to work. Plugging in multiple sensors gives an odd result. When I do that, not just that sensor but all the sensors return +127.75 degC, which is not the failure code (-127 degC). Also, sometimes a relay output I have coming out from Analog port 5 flickers when I read the sensors. I have had communication issues before, but not like this. I can't figure out why they would fail in this way.

Any thoughts? I'm stumped.

Thanks in advance to any generous and awesome person who can help me get more sleep :)

Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 1 post ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Powered by phpBB