It is currently Fri Aug 01, 2014 4:49 am


Post a new topicPost a reply Page 1 of 1   [ 1 post ]
Author Message
 Post subject: Need Sector's Help With Quad Copter Project
PostPosted: Wed Jan 22, 2014 9:21 pm 

Joined: Wed Jan 22, 2014 9:06 pm
Posts: 1
Hello, I am a student at UW Madison working on a design team competition (building a quad copter). Long story short I am looking to make plastic ducts for my fan blades. My plan is to make a cylindrical looking wood block (see pic) to then thermoform a plastic sheet over to make the duct shape (see pic). I was referred to Sector because no one at the university is willing to turn wood on their Lathe or Mill it either. I have attached images of the modeled wooden block and the finished product. The wood cylinder block would be about 13 inches in diameter. Someone told me you could probably help with both the turning of the wood and the thermoforming of the duct to boot! which would be awesome! Can sector help me out??

Attachment:
Wood block.PNG
Wood block.PNG [ 24.39 KiB | Viewed 134 times ]


Attachment:
Ducting.PNG
Ducting.PNG [ 15.44 KiB | Viewed 134 times ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 1 post ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron


Powered by phpBB